top of page
KISS ESC 2-5S 24A

KISS ESC 2-5S 24A Race Edition - 32bit brushless Motor Ctrl

SKU: pr1941
€29.90Price
Sales Tax Included |

Please see below for delivery times.

  • KISS ESC 2-5S 24A Race Edition

    KISS ESC 2-5S 24A Race Edition
    32bit brushless Motor Controller

    After more then a year of development, this revolutionary speed controller was intended to provide multirotor pilots with an experience they have never felt before.

    Even with the super simple motto, this ESC is still safe and intelligent with features such as current measurement/current limiting, temperature protection,and telemetry.

    Features

    32-Bit-ARM-Cortex MCU @ 48Mhz

    Telemetry capability (voltage, current, temp, rpm)

    Over-current protection (measures the current and reduces it to max 35A)

    Over temperature protection (reduces the max power if hotter then 120°C)

    Expanded adaptive auto timing (3,25-30° advance will be calculated on each commutation)

    For Race Multicopters (24A continuous also with bad cooling *)

    High max. RPM (450.000ERpm, 64.000Rpm with a 14 Pol Motor)

    Small size (19 x 27 mm)

    No additional capacitor needed**

    Very fast and direct response

    Active freewheeling (low diode losses)

    Regenerative braking

    Fast FET switching because of the use of gate drivers

    2-5S LiPo**

    Oneshot42, Oneshot125 and normal (25 – 500Hz) PWM auto detected.

    - Direct Memory Access -

    Guarantees a low CPU load using protocols like DSHOT 600/1200

    Hardware is prepared for using the newest digital protocols

    Operating voltage 6 – 25V

    500,000 ERPM maximum field speed (use of 450,000 recommended)

    Continuous A is 24A, max. is 35A, actively limited

    (*) e.g. When mounted between two CF plates

    (**) For very long LiPo power lines (more than 20cm) or for smoothing the power supply, attache a 100 – 400μF Low ESR 25V (or more) electrolytic capacitor

    to the power pads.

    Caution! When used with 5S lipo, the use of a electrolytic capacitor is recommended.

    Due to the regenerative braking, the KISS ESC should only be powered by LiPo batteries.

    Never start a brush-less motor in your hands!

    While starting up with propellers mounted, always care for distance to yourself and objects!

    Never power up your ESC/speed controllers without a valid signal transmitter (receiver or FC) is connected.

    The KISS ESC can be locally heated up to 80 ° C during operation!

    While soldering do not connect a voltage source at the ESC / speed controller.

    Please take care you are grounded while handling electronic devices.
    Some components on this device are electrostatic sensitive.









     

    Anleitung (DE)

    Manual


    Downloads


    Made in Europe

     

    All Downloads (Firmware, GUIs)

    This carrier fits the Kiss 24A REs.

    Carrier Board

    Connection Cable KISS FC -> KISS PDB for ESC24A

    as with any other ESC you can of course use the cables from our cable set.

    Cables and Shrinktube

bottom of page